| Model |
AP10 |
| Number of amplifier channels |
2 |
| 2Ω |
Not recommended |
| 4Ω |
1750W |
| 8Ω |
1000W |
| Bridge |
|
| 8Ω |
2500W |
| Protection |
DC current Protection, Short circuit Protection, Current limiting voltage protection, Overheat Protection |
| Audio performance |
|
| THD below 1kHz / 1dB |
< 0.09% |
| THD @ 20Hz-20kHz /1W |
< 0.058% |
| SNR |
> 100 dBA |
| Signal channel separation (crosstalk) @1KHz |
> 70 dB |
| Frequency response @1W 8Ohm, 20 Hz-20kHz |
+/- 0.05 dB |
| Damping control |
> 4000 |
| Analog input |
|
| Input impedance Balance / Unbalanced |
20 / 10 kohm |
| Gain |
|
| Amplifier gain |
34 dB |
| Rear panel interface |
|
| Analog channel |
3 PIN XLR (Including 2 x 3 audio link output) , Electronic balance input |
| Output connector |
speakon Neutrik（2 x nlt4） |
| Cooling |
Front and rear air flow, temperature controls flow speed |
| Control panel |
|
| Power ON/OFF |
Independent Power switch on front panel |
| Control |
A level attenuator for each channel |
| Indicators |
Independent LED indicator light for each channel; 1 x Power switch/Standby indicator (GREEN), 2 x signal indicator (GREEN), 2 x signal indicator (YELLOW)，2 x limiter indicator (RED) |
| Dust prevention |
Dust filter sponge at the rear of the front panel |
| Nominal voltage |
220 Volt AC 50 Hz |
| Working voltage |
200-250V AC |
| Universal power supply |
|
| Soft start / power supply |
Yes |
| Size |
W:483mm(19"),H:88mm(2U),D:385mm |
| Rack rail to rear panel |
|
| Weight |
21KG |
| Chassis appearance structure |
Aluminum front panel / Black coated steel chassis |
